还原 NAND备份

加入 DS⁽ⁱ⁾ 模式破解! Discord ,为本指南贡献力量。

DANGER

警告! 这非常 危险!!! 即使严格按照这些步骤操作也有可能使DSi变砖,因为机器的NAND闪存质量很低,尤其是如果你已经多次刷机! 这只能作为最后手段使用!

TIP

请勿跳过此页上的 任何步骤, 任何错误都会使得你DSi的变砖几率增加.

首先,除了你打算这样做的原因之外,还有几种更安全的替代选择:

  • 可以使用 hiyaCFW 或 TWiLight 菜单++安装DSiWare
  • 如果您想要在终端上同时使用 TWiLight Menu++与hiyaCFW ,可以使用 ninfs在新窗口打开来恢复图片。 HiyaCFW助手的最新版本允许您在设置过程中将您的照片从 NAND 复制到 SDNAND
  • Restoring an Unlaunch button configuration can be done from the Unlaunch menu, which can be accessed by holding A + B while powering the console on
  • 启动至Unlaunch导致错误? 取出SD卡,并且重启系统。 如果这有用,那么是SD卡出了错,还原NAND备份将不会修复它
  • "An error has occurred..." on boot is likely a hiyaCFW error and is not related to your NAND, see hiyaCFW FAQ & Troubleshooting在新窗口打开 on the DS-Homebrew Wiki for more information
  • TWiLight 菜单++中的任何错误都与NAND无关,您应该尝试重新安装 TWiLight 菜单++或在 Discord在新窗口打开 上寻求帮助
  • 除非绝对有必要,否则应避免通过刷入NAND或使用其卸载器来卸载 您可以将自动启动密钥设置为“Launcher”,您的 DSi就会恢复正常了

你唯一应该用你的NAND做的事情是安装Unlaunch 除此之外,请用其他替代方法

需要准备

提取BIOS 以便使用no$gba

  1. dsibiodumper.zip 压缩包中解压 dsibiosdumper.nds 并将其放置在你SD卡的任意位置
  2. 摁住 AB键 后,再摁下 Dsi 的电源键
    • 这应该能启动到Unlaunch Filemenu
  3. 从Unlaunch Filemenu启动 dsibiosdumper。
  4. A 将BIOS 导出到SD卡
  5. Start 退出 dsibiosdumer

测试你的NAND备份

在尝试将NAND备份恢复到您的机器之前,测试您的NAND备份是否能用非常重要, 如果它在no$gba 时显示变砖错误,它很可能也会使您的机器变砖。

  1. NO$GBA.EXEno$gba-w.zip 解压到您计算机上的一个文件夹中
  2. 将您的NAND备份复制到您放置 NO$GBA.EXE 的文件夹,并重命名为 DSI-1.MMC
  3. 复制 bios7i.binbios9i.bin 到您放置 NO$GBA. EXE的文件夹, 分别命名为 BIOSDSI7.ROMBIOSI9.ROM
  4. 运行 NO$GBA.EXE
  5. 点击 Options > Emulation Setup 来打开模拟器设置窗口
  6. 改变 Reset/Startup EntrypointGBA/NDS BIOS (Nintendo logo)
  7. 改变 NDS Mode/ColorsDSi (retail/16MB)
  8. Click Save Now
  9. 加载任何 NDS ROM (.nds 文件)

If no$gba loads the DSi menu (or the Unlaunch Filemenu), then continue to the next section. 如果出现任何错误 不要刷入那个备份

Uninstalling Unlaunch from your NAND backup (optional)

Follow this if you dumped your NAND backup after you installed Unlaunch and you would like to uninstall Unlaunch from your system. If you are not trying to uninstall Unlaunch, you do not need to do this section.

  1. Download the latest version of the Unlaunch installer在新窗口打开
  2. Extract UNLAUNCH.DSI from unlaunch.zip
  3. Launch UNLAUNCH.DSI in no$gba and start it from the Game Card slot
    • This should start the Unlaunch installer, which looks similar to to the Unlaunch Filemenu
  4. Choose Uninstall
  5. Once complete, choose Power down
  6. Launch any Nintendo DS ROM again, and ensure your DSi menu loads and is working properly

If no$gba shows any kind of error instead of loading the DSi menu, do not flash that backup! If you have an older NAND backup you may want to try using that instead. Do not try to uninstall Unlaunch using its uninstaller on the console, it is extremely likely doing so will brick your DSi.

刷入你的NAND备份 (软件方式)

DANGER

Make sure you have read through the above steps as this is where it gets dangerous. If you were linked directly to here without following the above, then go back to the top and read this whole page.

DANGER

Make sure your Nintendo DSi system is well charged before beginning this section.

  1. 在插入 SD 卡的状态下,按住 AB 开机
  2. 启动 SafeNANDManager
  3. 按下 begin NAND restore
  4. 一旦恢复完成,按 start 关闭您的 DSi

Your NAND should now be restored.

刷入你的NAND备份 (硬件修改)

If you cannot boot your Nintendo DSi, a hardmod is the only way to restore a NAND backup. The best guide that currently exists is the Nintendo DSi hardmod guide on the DS-Homebrew Wiki在新窗口打开.